Tech Tip: Oil Leak From Bell Housing/Torque Converter on Hyundai Models – UnderhoodService

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Underhood Service Logo
Technical resources to help diagnose and repair engine-related service issues.
Engine

Tech Tip: Oil Leak From Bell Housing/Torque Converter on Hyundai Models

Some transaxles may experience an oil leak in the bellhousing behind the torque converter. If this occurs, the oil leak will be observed at the drain hole on the lower surface of the transaxle.

Underhood Service Staff Writers
By Underhood Service Staff Writers
Published:

Repair Diagnosis:
If you are servicing a vehicle with this condition, refer to the below table to determine the proper repair procedure:

Related Articles

Repair Procedure:
1. Remove the transaxle.

2. Remove the torque converter.

3. Use a suitable tool to remove the oil seal.

4. Apply a thin coat of ATF to the lip of the oil seal before installation. Use the special tool (09452-21200) to install the oil seal (P/N 46131-36002) to the oil pump housing.

 

Technical service bulletin courtesy of Mitchell 1.

For more information on Mitchell 1 products and services, automotive professionals can log onto the company’s website at www.mitchell1.com.

 

You May Also Like

Engine

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Underhood Service magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers.
Published:

The basic function of a valve lifter is pretty simple. It sits on the camshaft and transfers the motions of the cam lobe up through the pushrods and rockers to open and close the valves. The size and shape of the cam lobe under the lifter (multiplied by the ratio of the rocker arms) determine valve lift and duration. As such, the lifter just follows the motions of the cam. But, it does play a role in valvetrain lash (clearance) and noise.

Read Full Article

More Engine Posts
Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

By Andrew Markel
Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

By Andrew Markel
Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

By Andrew Markel
Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

By Andrew Markel

Other Posts

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

By Andrew Markel
Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.

By Andrew Markel
Carbon Deposits and Direct Injection Engines

The primary cause of these problems is that fuel and added detergents are not hitting the back of the intake valves.

By Underhood Service Staff Writers
Acura Turbo Engine Service

It is important to check the operation of the solenoids that control vacuum to the actuators.

By Andrew Markel