Tech Tip: Silverado’s ABS Light Comes on at 40-50 mph – UnderhoodService

Tech Tip: Silverado’s ABS Light Comes on at 40-50 mph

At speeds over 40-50 mph, some owners of 1999 Silverados may complain that the ABS and brake indicators come on, and the fuel and volt gauges sometimes drop low at the same time. This tech tip provides information on how to diagnose and repair this condition.

Vehicle: 1999 Silverado.

Customer Complaint: At speeds over 40-50 mph, the ABS and brake indicators come on, and the fuel and volt gauges sometimes drop low at the same time.

The technician had already verified the condition and checked for codes before calling Identifix. He found code C0237 (rear wheel speed signal erratic) stored as a history code but it had not reappeared for him. Next he road-tested with a scanner, watching the vehicle speed input through the powertrain control module (PCM) and electronic brake control module (EBCM) data. When the ABS and brake light came back on, data was lost on the scanner for both the PCM and ABS. Something was crashing the class 2 data line — but what?

On this truck, the instrument panel cluster (IPC), body control module (BCM), EBCM, PCM and automatic transfer case control module (ATC) are all on the class 2 data line at pin 2 of the data link connector. The tech went to the splice pack (SP205) to determine which module was initially causing the problem. The splice pack joins all of the data circuits at one point, and is located on the lower left side of the dash behind the headlamp switch. The splice pack, a connector end with a jumper bar seated into it, is located on a short harness and often is taped to another harness. When the EBCM class 2 data wires were disconnected from the data line, the symptom was gone. Now we knew the EBCM circuit was causing the problem, so that left either a problem with the power/ground or the EBCM.

The tech checked the connector at the EBCM for corrosion and terminal condition — it was OK. Next he removed and cleaned the ground for the EBCM at the frame (see GM bulletin #04-05-25-002A). Using a headlamp to load the circuit, he load-tested the power and ground to the EBCM. The power and ground tested OK, but there was still a problem. A new EBCM fixed this one.

Written by IDENTIFIX GM Specialist Bill Siegmann. Bill is certified ASE Master and L1 with 20 years of diagnostic and repair experience.

For additional tech tips, visit www.identifix.com.

You May Also Like

Plastic Timing Chain Guides

Timing chain guides are designed to wear, but the guides are designed to last the engine’s life.

Timing chain guides are often the best indicators of the health of the timing chain, sprockets and the entire engine. Any abnormal noises or correlation codes need to be taken seriously. A timing chain guide is designed to keep the chain in tension so it will not flutter like a serpentine belt when the engine speed changes. 

Honda to Establish EV Value Chain in Ontario, Canada

It will strengthen EV supply system and capability with an eye toward a future increase in EV demand in North America, Honda said.

PRT Launches 30 New Complete Strut Assemblies

The new items represent more than 10 million vehicles in new coverage, PRT said.

BCA Bearings Unveils 2024 Endless Summer Promotion

The Endless Summer promotion runs from May 1 through June 30, 2024.

Ford- Illuminated MIL/Engine Coolant Over Temperature Warning

This may be caused by the engine coolant temperature (ECT) sensor or knock sensor wiring harness.

Other Posts

Mobis Starts Construction of EV Battery System Plant in Spain

The new EV battery system plant will supply Volkswagen and is aiming for mass production by 2026.

What Causes the White Crystals in an SCR System?

This video covers how detergents and surfactants in Diesel DEF Medic Plus clean the DEF system. This video is sponsored by Rislone.

Navistar Surpasses 100 Authorized EV Dealers

Navistar will have more than 30% of its dealer locations ready to support the sale and service of both International and IC Bus EVs.

It’s Got Spark!

Why can’t you trust some spark tests?