The Epic Story Of The Buick Turbo V6

Ultimate Underhood: The Epic Story Of The Buick Turbo V6

By 1986, the introduction of an intercooler and lightweight turbocharger gave the car an underrated 245 hp.

Buick started playing with turbochargers in 1976 when it paced the Indianapolis 500 with a Century equipped with a special turbocharged 3.8L V6. The actual pace car needed the boost cranked up to 22 psi to keep pace with the field. It produced 300 hp while the commemorative edition only had a V8 with 165 hp.

A turbocharged 3.8L didn’t go into production until 1978 when Buick developed a 165 hp that had an electronic spark control or a “turbo control center.” The system used engine knock sensors to detect preignition in order to retard ignition timing of the HEI distributor. Unfortunately, the turbo had to suck through a two- or four-barrel carburetor and blow through a restrictive catalytic converter. 

By 1984, the turbocharged 3.8L V6 in the Grand National had sequential fuel injection and a distributor-less “wasted spark” ignition system. A crankshaft sensor triggered the fuel injectors. Spark was trigged by a hall-effect camshaft position sensor. The coil pack and ignition module was made by Magnavox.

These innovations allowed the engineers to turn up the boost to produce 200 hp in 1984. By 1986, the introduction of an intercooler and lightweight turbocharger gave the car an underrated 245 hp. After 1987, the Grand National was killed off because the rear-drive Regal was going out of production. The last year for the Buick Turbo V6 was 1989, under the hood of the 20th Anniversary Pace Car Edition of the Pontiac Trans Am.

You May Also Like

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

What is a misfire? Is a misfire when the cylinder does not fire? Is it when the cylinder fires too soon or too late? The answer is “yes” to both questions. Some misfire complaints are a flashing check engine light, and a P0300 to P0312 diagnostic trouble code (DTC) indicates that one or more cylinders are misfiring. This is the easiest misfire to diagnose. But, what if there are no codes and a misfire is intermittent? This is where it gets complicated. 

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Other Posts

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.

Carbon Deposits and Direct Injection Engines

The primary cause of these problems is that fuel and added detergents are not hitting the back of the intake valves.