Oil Pressure Gauge Fluctuation After Startup and Over 3700 RPM

GM Tech Tip: Oil Pressure Gauge Fluctuation After Startup And Over 3700 RPM

The customer may comment that the oil pressure gauge jumps from approximately 40 lb. to 60 lb. three times within the first few minutes of driving as well when the engine revs past 3700 RPM.


Models:

2015-2018 Cadillac Escalade 6.2L L86
2014-2018 Chevrolet Silverado/GMC Sierra 1500 4.3L LV3 5.3L L83 6.2L L86
2015-2018 Chevrolet Suburban/Tahoe/GMC Yukon 5.3L L83

Condition
The customer may comment that the oil pressure gauge jumps from approximately 40 lb. to 60 lb. three times within the first few minutes of driving as well when the engine revs past 3700 RPM.

Cause
The 4.3L (LV3), 5.3L (L83), 6.2L (L86) engines are equipped with a two-stage oil pump.

The oil pressure gauge jumping three times is caused by a test routine the engine goes through during the first few minutes of driving to ensure that both stages are operable.

The oil pressure gauge going to 60 lb. over 3700 RPM, is the calibrated engine speed the oil pump goes into the high-pressure stage.

No repairs should be attempted, this is normal operation for these engines.

Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

You May Also Like

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Drive Belt Alignment Alignment is key to the health of an engine belt. The belt drive system is designed to create friction between the grooves on the belt and pulley to transfer power from the crankshaft to the alternator, water pump or power steering pump. If the grooves on the belt do not align with the pulleys, the friction won’t be evenly applied and can result in wear and noise.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Other Posts

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.