Tech Tip: Ford Truck No-Start Following CKP Replacement – UnderhoodService

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Underhood Service Logo
Technical resources to help diagnose and repair engine-related service issues.
Electronic

Tech Tip: Ford Truck No-Start Following CKP Replacement

After replacing the Crankshaft Position Sensor (CKP) and/or connector to correct another problem, the engine turns over, but does not start. The fuel injectors pulse a couple of times when the engine starts cranking, then they stop pulsing. There is an rpm reading on the scan data for a split second, then it goes to zero. There is no spark.

Underhood Service Staff Writers
By Underhood Service Staff Writers
Published:

Vehicle: 1997-2002 Ford F-150 4.2L, 4.6L and 5.4L; and 1996 Ford F-150 5.0L

Related Articles

Symptom: After replacing the Crankshaft Position Sensor (CKP) and/or connector to correct another problem, the engine turns over, but does not start.

The fuel injectors pulse a couple of times when the engine starts cranking, then they stop pulsing. There is an rpm reading on the scan data for a split second, then it goes to zero. There is no spark.  

Problem: Reversed Crankshaft Position Sensor (CKP) wiring

Test & Fix: This is the exact symptom of reversed polarity on the CKP sensor wires. It may be due to the wires being installed in the connector incorrectly during a terminal replacement, or a sensor that was installed has reversed polarity.

To Repair: At the CKP connector, remove the grey and blue wires from their respective terminals and reverse them in the connector and recheck for proper operation.

Courtesy of Identifix.

For more information, visit www.identifix.com. 

You May Also Like

Engine

Diagnosing Intercooler Boost Trouble Code P0299

The criteria for setting the code is very basic.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Underhood Service magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers.
Published:

A code P0299 for lower- than-normal boost can be one of the most challenging DTCs to resolve. You might think it is a code for a leak, but it could be more than a leak. The criteria for setting the code is very basic. The engine management system is looking at the desired boost pressure and the actual boost pressure, if the actual and desired do not match for the conditions. 

Read Full Article

More Electronic Posts
Why Alternators Are Subject To Ripple Voltage

The alternator produces an AC current that must be converted into DC current by way of a rectifier.

By Underhood Service Staff Writers
ECM Damage

Engineers have devised two strategies that can be called the “immune system” for the electrical system.

By Underhood Service Staff Writers
Voltage Drop Testing

The measurement of voltage is like the speed of the traffic.

By Andrew Markel
Spark Plug Fouling

Understanding why spark plugs get dirty.

By Andrew Markel

Other Posts

Auxiliary Water Pump Diagnostics

A car or truck comes into your shop with a complaint of poor heater performance- the issue may be the auxiliary water pump.

By Andrew Markel
Hybrid Vehicle Fluid Maintenance

There are opportunities your shop can’t pass up just because the car or SUV has a hybrid badge on the back.

By Andrew Markel
Ignition Coil Output

To see inductance inside the primary windings, use an amp probe placed around the positive wire for the ignition coil.

By Andrew Markel
Caring For AGM And Flooded Car Batteries

Faulty battery cables, if loose, corroded, or damaged, can lead to power drainage.

By Underhood Service Staff Writers