Ford Tech Tip: Lamp Flashing And Multiple Diagnostic Trouble Codes Present

Ford Tech Tip: Lamp Flashing And Multiple Diagnostic Trouble Codes Present

Some customers may complain of intermittent nuisance activation of the electronic stability control (ESC) during low-speed turning maneuvers while towing only a trailer.

Some 2009-2012 F-150 and 2010-2012 F-150 Raptor vehicles built on or before 6/10/2012 may exhibit a condition in which the traction control indicator is flashing or illuminated with diagnostic trouble codes (DTCs) C1278, C1280, C1282 and/or C1963 stored in the anti-lock brake system (ABS) module. 

Some customers may complain of intermittent nuisance activation of the electronic stability control (ESC) during low-speed turning maneuvers while towing only a trailer.

Reprogram the ABS Module to the latest calibration using IDS release 82.01 and higher. Calibration files must obtained at the site www.motorcraftservice.com.

You May Also Like

Detecting Misfire And Knock Conditions

Knock sensors are mounted on the block near the base of the cylinder head.

The knock sensor is a piezoelectric accelerometer that acts as a microphone on the engine. It converts vibrations into alternating current (AC) signal. When the crystal inside the sensor is vibrated, it produces an AC voltage. The greater the vibration or shock, the higher the voltage and frequency.

Mercedes Ignition Coil Pack Diagnostics

Replacing a single coil might not be the best approach to curing an engine of a chronic misfire.

Chrysler’s Totally Integrated Power Module

The TIPM is on the CAN bus, any issues with the communication between the ECM, ABS and BCM can cause problems with the TIPM.

Mercedes EQS Service Opportunities

EQ is the EV brand for Mercedes. It is the equivalent of Audi’s Etron or VW’s iD brands.

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Other Posts

Ford- Illuminated MIL/Engine Coolant Over Temperature Warning

This may be caused by the engine coolant temperature (ECT) sensor or knock sensor wiring harness.

Chassis Control Modules After Reconnecting Battery

To resolve the issue, fully disconnect the negative lead from the battery terminal.

Ford Pro, Xcel Energy Collaborate on EV Charging Port Installation

The effort aims to install 30,000 EV charging ports by 2030 for business fleets across Xcel Energy’s service territories in the U.S.

Reflashing Power Supplies

A power supply to keep the system voltage consistent is a required piece of equipment to perform a reflash procedure.