Tech Tip: Honda Civic 1.7L 2001-2005 Tensioner Spring Installation – UnderhoodService

Tech Tip: Honda Civic 1.7L 2001-2005 Tensioner Spring Installation

When installing a GTKWP312 kit on a 2001-2005 Civic 1.7L, it's crucial that the tensioner spring be installed correctly onto the tensioner. If it's improperly installed, the open end of the spring hook can catch on the timing belt, possibly leading to severe engine damage.

When installing a GTKWP312 kit on a 2001-’05 Civic 1.7L, it’s crucial that the tensioner spring be installed correctly onto the tensioner. If it’s improperly installed, the open end of the spring hook can catch on the timing belt, possibly leading to severe engine damage. figure 1: notice that the open end of the spring is incorrectly facing toward the timing belt, which could lead to severe engine ­damage if the hook snags or catches the edge of the timing belt.

The open end of the spring hook must be installed on the tensioner so that it is facing away from the belt and toward the engine block. The OE spring, which is included in the kit, should be replaced along with the other timing components. Use of the old spring will void the kit warranty.Figure 2 illustrates how to properly install the spring by facing the hook away from the timing belt so there is no threat of the spring snagging or catching the edge of the timing belt.

Remember, it’s important to replace all of the components included in the timing belt kit to validate the manufacturer’s warranty.

Courtesy of Veyance Technologies.

You May Also Like

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Drive Belt Alignment Alignment is key to the health of an engine belt. The belt drive system is designed to create friction between the grooves on the belt and pulley to transfer power from the crankshaft to the alternator, water pump or power steering pump. If the grooves on the belt do not align with the pulleys, the friction won’t be evenly applied and can result in wear and noise.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Other Posts

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.