Tech Tip: Surging Subaru Legacy Annoys Owner – UnderhoodService

Tech Tip: Surging Subaru Legacy Annoys Owner

Steve enjoys mountain biking, and his 2001 Subaru Legacy has no problem getting him to the mountains and back. Yet it doesn't like to commute. Steve called me after work one day to inquire about a surging problem the Legacy has had for a while. He said that the car would surge in low-speed traffic, especially after reaching operating temperature. We scheduled an appointment and I did some research. I discovered that the surging problem is common to some newer model Subarus.

By Eric Seifert
ALLDATA Automotive Technical Editor

Steve enjoys mountain biking, and his 2001 Subaru Legacy has no problem getting him to the mountains and back. Yet it doesn’t like to commute. Steve called me after work one day to inquire about a surging problem the Legacy has had for a while. He said that the car would surge in low-speed traffic, especially after reaching operating temperature. We scheduled an appointment and I did some research. I discovered that the surging problem is common to some newer model Subarus.

If you encounter a driveability concern such as idle surges or whistling, it may be caused by carbon buildup on the Idle Speed Control (ISC) valve. In these cases, it is not necessary to replace the ISC valve. Cleaning the ISC valve could correct the condition. To clean an ISC valve, perform the repair procedure.

Applicable Vehicles
1999 Legacy 2.2L CAL
2000-’01 Legacy 2.5L MT
All Legacy 3.0L MT
2004 Baja 2.5L Turbo
1999 Impreza 2.2L CAL
2000-’01 Impreza 2.2L
2002-’04 Impreza 2.0/2.5L Turbo

REPAIR PROCEDURE
Normally Aspirated Vehicles:
1. Warm up the engine.
2. On 2.2L/2.5L engines only, remove the bolt that attaches air cleaner case B to the bracket. See Figure 1. Undo the three clips that hold together air cleaner case B to air cleaner case A. Remove air cleaner case B and the air cleaner element and set aside. (On all 3.0L H6, remove the entire air intake chamber).

3. Start the car and maintain engine speed between 1,000 and 1,500 rpm.
4. Spray engine cleaner (GM P/N 12345089 GM Top Engine Cleaner or equivalent) toward the upper air-stream of the throttle chamber for approximately 10 seconds.
5. Stop the engine and let it sit for three minutes.
6. Restart the engine and maintain 1,000 to 1,500 rpm.
7. Spray engine cleaner on the upper air-stream of the throttle chamber for approximately 10 seconds.
8. Turn off the engine.
9. Reinstall the air cleaner element and air cleaner case B.
10. Operate the car between 1,000 and 2,000 rpm until no white smoke appears through the tailpipe.
11. Turn off the ignition switch and clear the memory.

For Turbo Vehicles:
1. Warm up the engine.
2. Remove the intercooler (see Figure 2) and set aside.
3. Disconnect the mass airflow (MAF) sensor connector.
4. Cycle the key “on/off” once (to enter “failsafe” mode).
5. Start the car and maintain engine speed between 1,000-1,500 rpm.
6. Spray engine cleaner (GM P/N 12345089 Top Engine Cleaner or equivalent) on the upper air-stream of the throttle chamber for approximately 10 seconds.
7. Stop the engine and let it sit for three minutes.
8. Restart the engine and maintain 1,000 to 1,500 rpm.
9. Spray engine cleaner on the upper air-stream of the throttle chamber for approximately 10 seconds.
10. Turn off the engine.
11. Reinstall the intercooler and reconnect the MAF sensor connector.
12. Operate the car between 1,000-2,000 rpm until no white smoke appears through the tailpipe.
13. Turn off the ignition switch and clear the memory.

Written by ALLDATA Technical Editor Eric Seifert, an ASE certified Master Technician and Engine Machinist, with 20 years of independent shop and parts store experience.

For additional information, visit www.alldata.com.

You May Also Like

Clarios to Supply High-Performance AGM Battery to Major OEM

It offers up to 80% reduction in CO2 emissions over traditional AGM batteries, in many cases, Clarios said.

Clarios, producer of one in three of the world's low-voltage car batteries, said it secured a supplier contract with a major original equipment manufacturer for its new high-performance recharge absorbent glass mat (AGM) battery – a 12-volt battery with increased charge acceptance compared to traditional AGM batteries to help reduce fuel consumption and to help reduce CO2 emissions.

FLO, GM Activate Plug and Charge for GM EV Drivers in Canada

FLO’s technology confirms identification, authorizes the charging session and activates billing without any additional action from the driver.

Schaeffler and Sustainability with Jerry Conroy

Conroy shares insights into his career trajectory, the evolving landscape of the company’s aftermarket operations, and its commitment to innovation and sustainability.

Flushing the Brake Fluid is Critical on Every Brake Repair

Making sure the brake fluid is the correct quality is critical. Sponsored by Auto Value and Bumper to Bumper.

Selecting the Right Oil for your Customers Engine

Learn how to educate customers on the importance of OEM specifications and premium lubrication for their vehicles’ maintenance needs.

Other Posts

At the Intersection of Tradition and Innovation with Grace Hovis

Grace Hovis’s journey in Hovis Auto & Truck Supply blends tradition with digital innovation in the automotive aftermarket industry.

Inspection Tips For Chain-Driven Water Pumps

If one water pump fails sooner and is replaced without an investigation, the new pump is likely doomed.

Water pump feature
Power Window Regulator and Motor Service

Power windows are great as long as they roll up and down when commanded to do so.

Philips Announces GoPure GP5212 Automotive Air Purifier

It uses a 3-layer filter to deliver cleaner, healthier, fresher air on the go, Lumileds said.