Tech Tip: Volkswagen Check Engine Light Is On, Trouble Code P2181 – UnderhoodService

Tech Tip: Volkswagen Check Engine Light Is On, Trouble Code P2181

Vehicle Application:

2002 Golf GTI 1.8L and Jetta GLS Wagon 1.8L;

2003 Beetle 1.8L and 2.0L; Jetta GLS Wagon 1.8L and GLS 2.0L; and Passat 1.8L;

2004 Beetle 1.8L and 2.0L; Jetta 2.0L and GLS 2.0L;

2005 Beetle 2.0L; and

2006 Passat 2.0T 2.0L

 

 

Customer Concern:

Check Engine light is on. Trouble code: P2181 (18613).

Potential Causes:

– Connector

– Defective Coolant Temperature Sensor (CTS) Wiring

– Defective Thermostat

 

Tests/Procedures:

1. Measure engine temperature and ensure it is getting up to proper operating temperature.

2. Connect a Volkswagen-compatible scan tool and monitor engine temperature on the scan tool. Compare to the actual engine temperature to determine if the coolant sensor is working correctly.

Tech Tips:

Code P2181 (18613) is for cooling system performance. It generally means that the vehicle has a defective or leaking thermostat. If the vehicle does not warm up quickly enough to go into closed loop operation within the time programmed into the engine control module, it will set this code. This is generally cured by replacing the thermostat.

Courtesy of Identifix, Inc.

You May Also Like

Why Alternators Are Subject To Ripple Voltage

The alternator produces an AC current that must be converted into DC current by way of a rectifier.

Alternators have been used to charge the 12V DC electrical systems in vehicles since long before computers and networks were part of the equation. Just a few decades ago, the 12V DC electrical system wasn’t that vulnerable to ripple voltage. Today however, excessive ripple voltage can cause major communication issues across networks and can cause a number of communication DTCs to be set in multiple control modules.

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Other Posts

Why Does Engine Coolant Need Replacement?

Two specifications can be used to justify replacement — the condition of the additive package & the freezing point.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Engineering Better Belt Systems

An accessory drive belt is always both speeding up and slowing down.