Tech Tip: Nissan Engine Will Not Crank with Outside Temperature Below 10 – UnderhoodService

Tech Tip: Nissan Engine Will Not Crank with Outside Temperature Below 10

A no crank condition may call for replacement of the Intelligent Power Distribution Module-IPDM.

Confirm a “no crank” (starter doesn’t work) incident under all of the ­following conditions:

1. The vehicle sat for several hours (cold soak) with outside temperatures below 10° F (-12° C).

2. The vehicle was then driven for a short period of time (5-10 minutes).

3. The engine was then turned off for a short time (5-10 minutes).

4. The engine would then not crank when a restart was attempted (starter doesn’t work).

Note: This TSB applies only if all of the above ­conditions occurred.

Applied Vehicles:
• 2002-’06 Altima (L31);
• 2004-’06 Maxima (A34);
• 2004-’06 Quest (V42);
• 2003-’06 Murano (Z50);
• 2003-’06 350Z (Z33);
• 2004-’06 Titan (A60);
• 2004-’06 Armada (TA60);
• 2005-’06 Pathfinder (R51);
• 2005-’06 Xterra (N50); and
• 2005-’06 Frontier (D40).

  Chart 1

Action
Replace the Intelligent Power Distribution Module-IPDM (see chart below). For IPDM replacement information, go to the service manual, section PG, ­Removal and Installation of IPDM E/R.

Courtesy of Mitchell 1.

You May Also Like

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Drive Belt Alignment Alignment is key to the health of an engine belt. The belt drive system is designed to create friction between the grooves on the belt and pulley to transfer power from the crankshaft to the alternator, water pump or power steering pump. If the grooves on the belt do not align with the pulleys, the friction won’t be evenly applied and can result in wear and noise.

ECM Damage

Engineers have devised two strategies that can be called the “immune system” for the electrical system.

Voltage Drop Testing

The measurement of voltage is like the speed of the traffic.

Spark Plug Fouling

Understanding why spark plugs get dirty.

Understanding Stop/Start Charging and Starting Systems

The problem may not have been caused by a complicated reason, something simple may have caused the system not to work.

Other Posts

Hybrid Vehicle Fluid Maintenance

There are opportunities your shop can’t pass up just because the car or SUV has a hybrid badge on the back.

Ignition Coil Output

To see inductance inside the primary windings, use an amp probe placed around the positive wire for the ignition coil.

Caring For AGM And Flooded Car Batteries

Faulty battery cables, if loose, corroded, or damaged, can lead to power drainage.

Power Window Regulator and Motor Service

Power windows are great as long as they roll up and down when commanded to do so.