Engine Noise Turns Out to Be Groundhog Along for a Ride – UnderhoodService

Engine Noise Turns Out to Be Groundhog Along for a Ride

Rebecca Martin was running errands in Athens, OH, Tuesday when she heard a knocking noise coming from her engine. Concerned, she pulled into a Walmart parking lot and lifted the hood. It turns out the noise she heard was coming from a stowaway groundhog.

Rebecca Martin was running errands in Athens, OH, Tuesday when she heard a knocking noise coming from her engine. Concerned, she pulled into a Walmart parking lot and lifted the hood. It turns out the noise she heard was coming from a stowaway groundhog.

Below is the article as it appeared on the WXIN-TV Channel 59 website.

Knocking under Ohio woman’s hood not engine gremlins but stowaway groundhog

By Associated Press
10:23 AM EDT, May 27, 2010

ATHENS, Ohio (AP) — An Ohio woman needed animal control, not a mechanic, when it turned out the thumping under her car’s hood was coming from a stowaway groundhog.

Rebecca Martin says she heard the noise Tuesday while running errands with other family members in Athens in southeast Ohio.

When they pulled over in a Walmart parking lot and lifted the hood, Martin says up popped one of the largest groundhogs she’d ever seen. It then choose to burrow in near the engine, so 911 was called.

Athens County Dog Warden Jeff Koons responded, and it took him more than 5 minutes to get the critter to come out. When it finally did, it scurried across Martin’s feet and eluded Koons for another half-hour hiding under cars. He captured the groundhog and released it in a rural area.

Information from: The Athens Messenger, http://www.athensmessenger.com/.

You May Also Like

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Drive Belt Alignment Alignment is key to the health of an engine belt. The belt drive system is designed to create friction between the grooves on the belt and pulley to transfer power from the crankshaft to the alternator, water pump or power steering pump. If the grooves on the belt do not align with the pulleys, the friction won’t be evenly applied and can result in wear and noise.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Other Posts

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.