Honda Tech Tip: Oil Pressure Switch Fails Intermittently – UnderhoodService

Honda Tech Tip: Oil Pressure Switch Fails Intermittently

The MIL comes on with one of these DTCS: P3400 (VPS Stuck Off Bank 1) or P3497 (VPS Stuck Off Bank 2). This may be the result of the front and/or rear rocker arm oil pressure switch intermittently failing.

MODELS

2008-2011 Accord 2-door/4-door

2012 Accord 2-door/4-door (select VINs)

2010-11 Crosstour 2WD/4WD

2012 Crosstour 2WD/4WD V6 (select VINs)

2008-11 Odyssey EX-Land Touring

2012 Odyssey (select VINs)

2009-11 Pilot 2WD/4WD

2012 Pilot 2WD/4WD (select VINs)

SYMPTOM

The MIL comes on with one of these DTCS:

• P3400 (VPS Stuck Off Bank 1)

• P3497 (VPS Stuck Off Bank 2)

NOTE: The symptom may be intermittent, and you may not be able to duplicate it after clearing the DTC.

POSSIBLE CAUSE

The front and/or rear rocker arm oil pressure switch may fail intermittently.

Photo 1
Photo 1

DIAGNOSIS

Check the engine oil level on the dipstick. If the engine oil level is below the end of the dipstick (there is no oil on the dipstick), this service bulletin does not apply. The low engine oil level is likely the cause of the DTCs; continue with normal troubleshooting.

• If the engine oil level is on the dipstick (it may be low, but there is oil on the dipstick), go to the Repair Procedure.

REPAIR PROCEDURE

1. Remove the engine cover. (photo 1)

Photo 2
Photo 2

2. Remove the appropriate rocker arm oil pressure switch(es) depending on the DTCS stored. (photo 2)

  • P3400 – Replace the Bank 1, rear rocker arm oil pressure switch.
  • P3497 – Replace the Bank 2, front rocker arm oil pressure switch.

3. Install the new rocker arm oil pressure switch(es) and new O-ring(s). Torque the oil pressure switch to 22 N.m (16 lb-ft).

4. Reinstall the engine cover.

5. Clear the code(s) with the HDS.

NOTE: If the DTC returns, refer to the troubleshooting procedure for the DTC that is set.

Courtesy of ALLDATA

You May Also Like

Check Out The December Issue Of Underhood Service Magazine

The digital version of the December issue of Underhood Service is available on-line. Access the easy-to-view digital version that features articles on Spark Plug Service, Hyundai Oxygen Sensor Codes, CAN Bus Diagnostics, Subaru Stretch Belt Replacement, a host of Tech Tips, and more!

The digital version of the December issue of Underhood Service is available on-line.

CLICK HERE to access the easy-to-view digital version that features articles on Spark Plug Service, Hyundai Oxygen Sensor Codes, CAN Bus Diagnostics, Subaru Stretch Belt Replacement, a host of Tech Tips, and more!

Transmission Line Replacement

Transmission fluid likes to be at a constant temperature. If it is too hot or too cold for too long, the performance can fluctuate and potentially cause damage to the transmission.

VIDEO: AAPEX 2016 Insights

Andrew Markel discusses his take on conversations he had with economists at AAPEX 2016, including the future of purchasing parts.

BMW Tech Tip: Oil Separator Replacement

A clogged oil separator valve is a common problem on many BMW DOHC inline sixes. The high failure rate is caused by sludge build-up that can result in oil burning, rough idle and engine fault codes. Although the solution is pretty simple, replacing the valve is labor intensive and can take anywhere from six to nine hours.

New IDUSA Premium Guard Website Offers Easy Access To Wide Range Of Oil, Air, Cabin, Fuel And Transmission Filters

The new website’s bi-lingual, responsive design features look-up powered by ShowMeTheParts.

Other Posts

VIDEO: How To Deal With Air Conditioning Smells

Andrew Markel discusses what to do to get rid of A/C smells after customers have tried to do it themselves.

Oil Bath Air Filters

Long before people started using cotton gauze air filters soaked in oil, the oil bath air filter was the dominant filter on the market. The filter removes debris in the air by running it over oil and a mesh element. These filters worked great when most roads were dirt, but they could be messy to clean.

On The Web – September 2016

Finding Failing O2 Sensors If an O2 sensor gets “lazy” because of old age or contamination, the computer may not be able to adjust the fuel mixture quickly enough as the engine’s operating conditions change. Related Articles – Join Underhood Service On LinkedIn – Fuel Trim And AFR Sensors – Check Out The August Issue

Join Underhood Service On LinkedIn

Related Articles – Hayden Automotive Introduces Low-Profile Fan Clutch – Belt Inspection Checklist – Preventive Maintenance Profits: Preferred Automotive, Jenkintown, PA                     Underhood Service’s LinkedIn Page                         Underhood Service’s LinkedIn Group