Chrysler No-Start After Being Parked

Chrysler No-Start After Being Parked

When leaving a Chrysler PT Cruiser parked for an extended period of time, it could fail to start.

MODELS

2001 Chrysler PT Cruiser, L4-2.4L, VIN B, Automatic

Problem

This vehicle was parked for several months and moved only about 50 feet once a week. The owner towed it to the shop because, the last time he tried to move it, the engine would crank but not start.

Case Details 

The technician connected a scan tool but found no diagnostic trouble codes (DTCs) or anti-theft lights. He did find that there was no spark or injector pulse, so he replaced the crankshaft position sensor. Unfortunately, that did not fix the problem, so he called ALLDATA Tech-Assist. The Tech-Assist consultant mentioned that auto shut down (ASD) relay failures are common on PT Cruisers. He sent the technician a wiring diagram to indicate where to check the (B+) voltage and ground supplies to the ignition coil, fuel injectors and PCM. The consultant advised that if those were all in good condition, then the ASD relay was likely the problem.

Confirmed Repair

The technician performed the recommended circuit tests and found all (B+) voltage and grounds were good. After replacing the ASD relay, the engine started right up and ran without any problems. Fixed! 

Courtesy of ALLDATA

You May Also Like

Deciphering Engine Misfire Codes

When the fuel/air mixture ignites, many factors must be met to pass a misfire monitor.

Misfires can be one of the most ambiguous codes. The cause of the misfire could be a fuel, spark or mechanical issue. Is a misfire when the cylinder does not fire? Is a misfire when the cylinder fires too soon or too late? The answer is “yes” to both questions. Some misfire complaints are a flashing check engine light, and a P0300 to P0312 diagnostic trouble code (DTC) indicates that one or more cylinders are misfiring. 

Detecting Misfire And Knock Conditions

Knock sensors are mounted on the block near the base of the cylinder head.

Mercedes Ignition Coil Pack Diagnostics

Replacing a single coil might not be the best approach to curing an engine of a chronic misfire.

Chrysler’s Totally Integrated Power Module

The TIPM is on the CAN bus, any issues with the communication between the ECM, ABS and BCM can cause problems with the TIPM.

Mercedes EQS Service Opportunities

EQ is the EV brand for Mercedes. It is the equivalent of Audi’s Etron or VW’s iD brands.

Other Posts

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Chassis Control Modules After Reconnecting Battery

To resolve the issue, fully disconnect the negative lead from the battery terminal.

Reflashing Power Supplies

A power supply to keep the system voltage consistent is a required piece of equipment to perform a reflash procedure.

BMW Transfer Case Service

The transfer case is a rather unique design in the way that it operates a clutch pack mechanically, not hydraulically.