Lifetime Air Filters: Fad Or Future?

Lifetime Air Filters: Fad Or Future?

In 2005, Ford took the air filter game to a new level by introducing a lifetime air filter on Ford Focus models with the 2.0L or 2.3L PZEV engines. If you are thinking this was an oiled cotton filter, you are wrong. The filter was designed to last the lifetime of the vehicle and would never need service or replacement.

In 2005, Ford took the air filter game to a new level by introducing a lifetime air filter on Ford Focus models with the 2.0L or 2.3L PZEV engines. If you are thinking this was an oiled cotton filter, you are wrong. The filter was designed to last the lifetime of the vehicle and would never need service or replacement.

The rumor is that for the Focus to get the PZEV rating, it had to meet specific anti-tampering and lower maintenance requirements. In the early 2000s, many of the requirements brought about larger catalytic converters and double platinum spark plugs that could go 125,000 miles before replacement.

The lifetime promise could be made because the filter used traps and advanced foam filter media that increased the capacity of the filter without hurting its efficiency. The filter used different layers of foam with different levels of filtering. The larger particles could be separated from the airflow before reaching the filter media designed to stop small particles. It was a technology that was ahead of its time.

But, a lifetime for one driver is not the same as a lifetime for another driver. The lifetime for normal service, according to Ford, was about 150,000 miles. But, if the driver lived on a dusty road, a lifetime might be shorter. Drivers reported clogged filters in as little as 80,000 miles, while others had operational filters well past 200,000 miles.

The filter was located in the driver’s side wheel well and required the removal of the fender liner and other components to access it. The air filter assembly includes a restriction gauge that can be seen from under the hood. The gauge is like a diesel air filter gauge with red, yellow and green indicator levels.

If the filter is restricted, the assembly can cost as high as $500 and bill .3 hours of labor. But, many filters never made it to their lifetime mileage where they became restricted; often the filters were damaged in collisions or encounters with snow banks or curbs. When the housing is damaged, the most common symptom is a code for a lean fuel trim because the mass airflow sensor is located on the assembly.

There are solutions in the aftermarket. Companies have introduced filter housings that can accept a conventional-style panel air filter. This option can reduce the replacement cost in half.

You May Also Like

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Drive Belt Alignment Alignment is key to the health of an engine belt. The belt drive system is designed to create friction between the grooves on the belt and pulley to transfer power from the crankshaft to the alternator, water pump or power steering pump. If the grooves on the belt do not align with the pulleys, the friction won’t be evenly applied and can result in wear and noise.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Other Posts

Air Filters and Fuel Trims

Modern engines rely on precise airflow and oxygen sensor data for optimal performance.

car-air-filter
Diesel Air Filter Replacement

Here are some diesel air filter replacement tips in order to keep these vehicles running as intended.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.