Tech Tip: Volkswagen Check Engine Light Is On With Trouble Code P2187 – UnderhoodService

Tech Tip: Volkswagen Check Engine Light Is On With Trouble Code P2187

The check engine light is on, with trouble code P2187, too lean off idle bank 1. This "Fast Fix" from Identifix shows how one tech solved this issue.

Vehicle: 2004 Volkswagen Beetle GLS 2.0L, L4, MFI, SOHC

Customer Concern: The check engine light is on, with trouble code P2187, too lean off idle bank 1.

Potential Causes:
– Defective Mass Air Flow (MAF) Sensor
– Leaking Engine Vacuum
– N80 Canister Purge Solenoid

Tests:

1. Check and verify that there are no vacuum leaks or ­un-metered air leaks.

2. Check the MAF sensor grams/second readings as ­follows:

  a. Idle (about 830 rpm) 3.5 grams/sec. or more (4 to 4.5 grams/sec. preferred).

  b. 2,500 rpm no load, 9 to 15 grams/sec. (11 to 12 grams/sec. preferred).

  c. Wide open throttle road (WOT) load (drive vehicle at 45 mph in third gear and perform a WOT acceleration, observe maximum indicated grams/sec. readings on the MAF); 90 or more grams/sec. preferred.

  d. A MAF that exhibits ­consistently lower than normal grams/sec. readings can cause a P0102 code to set.

3. Check for a leaking N80 Canister Control Valve. This can cause a vacuum leak and a lean idle condition.

Confirmed Fix: Replaced the MAF sensor.

Courtesy of Identifix’s “Five Fast Fixes.”

You May Also Like

Why Alternators Are Subject To Ripple Voltage

The alternator produces an AC current that must be converted into DC current by way of a rectifier.

Alternators have been used to charge the 12V DC electrical systems in vehicles since long before computers and networks were part of the equation. Just a few decades ago, the 12V DC electrical system wasn’t that vulnerable to ripple voltage. Today however, excessive ripple voltage can cause major communication issues across networks and can cause a number of communication DTCs to be set in multiple control modules.

Tech Tip: No Start in Cold Weather Due to No Weep Hole

This condition can be caused by condensation freezing in the muffler assembly.

Determining Catalytic Converter Efficiency

Almost every part on the engine determines how long a catalytic converter will last.

Talking To Customers About Oxygen Sensors

One of the toughest components to sell as a maintenance item, or even a replacement item, is an oxygen sensor.

PCV System DTC

PCV systems are far more complex now, but they are also much better at controlling crankcase pressure.

Other Posts

Hybrid Vehicle Fluid Maintenance

There are opportunities your shop can’t pass up just because the car or SUV has a hybrid badge on the back.

Ignition Coil Output

To see inductance inside the primary windings, use an amp probe placed around the positive wire for the ignition coil.

Belts and Pulley Alignment

A misalignment of the plane of the belt can occur when a pulley is not parallel to the other pulleys on the belt drive system.

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated.