Honda Tech Tip: Low Tire Pressure And TPMS Indicator On After Recent Tire Replacement

Honda Tech Tip: Low Tire Pressure And TPMS Indicator On After Recent Tire Replacement

The Honda CR-V uses an indirect TPMS system that uses the rolling circumference of the tire to determine the pressure in the tire. Differences in sidewall construction and weight of a replacement tire can cause the rolling circumference to change if a single tire is replaced.

Models: 2014-2016 CR-V

The Honda CR-V uses an indirect TPMS system that uses the rolling circumference of the tire to determine the pressure in the tire. Differences in sidewall construction and weight of a replacement tire can cause the rolling circumference to change if a single tire is replaced. Because of the way indirect TPMS works, those differences will cause the Low Tire Pressure/TPMS indicator to come on.

One of the original equipment tires is the Continental CrossContact LX, size 225/65R17 (P/N 42751-CTL-010, DOT ID CN5L). Made in France, it has a 1-ply sidewall construction. These tires have been discontinued, but there’s a limited supply still available until they run out. 

The official replacement tire is now made in Portugal. This tire (P/N 42751-CTL-027, DOT ID AF5L) has a 2-ply sidewall construction. 

There’s also a U.S.-made tire (P/N 42751-CTL-009, DOT ID A32Y) that will work. It has a 2-ply sidewall construction, but it’s a bit heavier than the French- and Portuguese-made tires.

The online owner’s manual for the 2014-2016 Honda CR-V recommends replacing all four tires at the same time. But if that’s not practical, the French- and Portuguese-made tires should be replaced as a pair (right and left front tires, right and left rear tires). Since the U.S.-made tires are heavier than the French- and Portuguese-made tires. all four tires must be replaced.

You May Also Like

Detecting Misfire And Knock Conditions

Knock sensors are mounted on the block near the base of the cylinder head.

The knock sensor is a piezoelectric accelerometer that acts as a microphone on the engine. It converts vibrations into alternating current (AC) signal. When the crystal inside the sensor is vibrated, it produces an AC voltage. The greater the vibration or shock, the higher the voltage and frequency.

Mercedes Ignition Coil Pack Diagnostics

Replacing a single coil might not be the best approach to curing an engine of a chronic misfire.

Chrysler’s Totally Integrated Power Module

The TIPM is on the CAN bus, any issues with the communication between the ECM, ABS and BCM can cause problems with the TIPM.

Mercedes EQS Service Opportunities

EQ is the EV brand for Mercedes. It is the equivalent of Audi’s Etron or VW’s iD brands.

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Other Posts

Chassis Control Modules After Reconnecting Battery

To resolve the issue, fully disconnect the negative lead from the battery terminal.

Reflashing Power Supplies

A power supply to keep the system voltage consistent is a required piece of equipment to perform a reflash procedure.

BMW Transfer Case Service

The transfer case is a rather unique design in the way that it operates a clutch pack mechanically, not hydraulically.

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and you’ll need a scan tool to measure the signals