ITM’s TPMS Uni-sensor Fulfills Shops’ Needs With Two SKUs – UnderhoodService

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Underhood Service Logo
Technical resources to help diagnose and repair engine-related service issues.
Diagnostics

ITM’s TPMS Uni-sensor Fulfills Shops’ Needs With Two SKUs

The ITM Uni-sensor is one of the first programmable TPMS programs that provides 95% vehicle application coverage for domestic, Asian and European vehicles.

Underhood Service Staff Writers
By Underhood Service Staff Writers
Published:

Related Articles

The ITM Uni-sensor is one of the first programmable TPMS programs that provides 95% vehicle application coverage for domestic, Asian and European vehicles.

There are currently more than 147 SKUs of OE TPMS sensor applications and the number continues to grow. Uni-sensor presents a programmable sensor that requires only a single programming tool — the sensor AID, which is also a diagnostic/scan and re-trigger/relearn tool for your TPMS service needs.

The ultimate objective of the Uni-sensor is to reduce a tire dealer’s and repair shop’s inventory by more than 95% with just two SKUs (315 MHz sensor and 433 Mhz sensors available in both clamp-in or snap-in).

 

You May Also Like

Diagnostics

Detecting Misfire And Knock Conditions

Knock sensors are mounted on the block near the base of the cylinder head.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Underhood Service magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers.
Published:

The knock sensor is a piezoelectric accelerometer that acts as a microphone on the engine. It converts vibrations into alternating current (AC) signal. When the crystal inside the sensor is vibrated, it produces an AC voltage. The greater the vibration or shock, the higher the voltage and frequency.

Read Full Article

More Diagnostics Posts
Mercedes Ignition Coil Pack Diagnostics

Replacing a single coil might not be the best approach to curing an engine of a chronic misfire.

By Andrew Markel
Chrysler’s Totally Integrated Power Module

The TIPM is on the CAN bus, any issues with the communication between the ECM, ABS and BCM can cause problems with the TIPM.

By Andrew Markel
Mercedes EQS Service Opportunities

EQ is the EV brand for Mercedes. It is the equivalent of Audi’s Etron or VW’s iD brands.

By Underhood Service Staff Writers
ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

By Andrew Markel

Other Posts

Chassis Control Modules After Reconnecting Battery

To resolve the issue, fully disconnect the negative lead from the battery terminal.

By Underhood Service Staff Writers
Reflashing Power Supplies

A power supply to keep the system voltage consistent is a required piece of equipment to perform a reflash procedure.

By Andrew Markel
BMW Transfer Case Service

The transfer case is a rather unique design in the way that it operates a clutch pack mechanically, not hydraulically.

By Underhood Service Staff Writers
Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and you’ll need a scan tool to measure the signals

By Andrew Markel