You searched for O-Ring - Page 5 of 28 - UnderhoodService
Don’t Fear The Turbo

The turbocharger gets a bad rap. So many technicians can name reasons why they have failed in the past, yet they can’t recall when or why a turbocharger has failed recently. With more and more vehicles employing a turbocharger to achieve power and fuel efficiency from a downsized engine, the importance of maintenance is more critical than ever.

Ford Power Stroke Guide

Ford Power Stroke diesel engines have a history that dates back to 1994. The first in this series was the 7.3L engine, which was designed by Navistar for Ford. The 7.3L featured direct injection and turbocharging, and was probably the most reliable and durable engine in the series. The only major problems with these engines have been hard cold starts due to extreme valve seat wear or leaky O-rings on the injectors.

Bar’s Leaks, Rislone And Hy-per Lube To Launch New Products, Updated Packaging At AAPEX 2018

Bar’s Leaks will introduce four chemical stop leak products at AAPEX 2018. The Bar’s Leaks/Rislone/Hy-per Lube booth No. 3616 also will showcase a range of new packaging and label enhancements for many of its products. AAPEX 2018 runs from Oct. 30 to Nov. 1 at the Sands Expo Center in Las Vegas. The Bar’s Leaks/Rislone/Hy-per

Sealing Modern Water Pumps

Over the past 20 years, we have seen water pumps and cooling systems evolve to improve start-up emissions.

VANOS Variable Valve Timing Diagnostics

Diagnosing a VANOS system does not require that you speak German. What it does demand, however, is knowledge of how the actuator adjusts the camshaft, how the solenoid controls the actuator and when the engine control module changes camshaft timing. As for tools, you will need the appropriate tool set to lock the crank and camshaft. You will also need a scan tool and a scope to observe the crankshaft and camshaft signals to accomplish more advanced diagnostics.

Tech Tip: Ford 3.5 Ecoboost With Blue Or White Smoke From Exhaust

Some 2013-2015 models vehicles equipped with a 3.5L Gasoline Turbocharged Direct Injection (GTDI) engine may exhibit blue or white smoke from the exhaust while driving after extended idle.

A/C Compressor Replacement: Doing A Visual Inspection & Checking For Leaks And Debris Eases Diagnostics

One thing on your customers’ minds during the summer driving months is air conditioning – as in, will it work when they need it. Driving around in the hot summer heat can take a toll on the A/C system, so, chances are, you’ll be doing a lot of HVAC repairs from now until the end of September.

Acura Tech Tip: Chirping From High-Pressure Fuel Pump

With the hood open, listen for a chirping noise with the engine warmed up. If the noise is coming from the high-pressure fuel pump, follow the Repair Procedure in this Tech Tip.

Volkswagen, Audi Direct Fuel Injection System

For the past decade, almost every vehicle that Volkswagen and Audi has sold in the U.S. has been equipped with direct fuel injection. These FSI, TSI and GDI systems allow for better fuel economy and power. The switch to direct injection has also allowed Volkswagen to downsize its engines from 2.0L to 1.4L on base models without losing any power, while still improving fuel efficiency.

Corrosion And TPMS

It is that time of year again when the affects of road salt, deicers and potholes start to take their toll on vehicles. The latest victims of the salt belt are TPMS sensors and valve stems. The corrosion we are all most familiar with is that which affects steel, iron’s most common alloy. While just the presence of oxygen in the air, along with some moisture, is enough for something made of steel to begin to corrode, most of the time it is accelerated by some other environmental factor, which causes the most problems.