Permatex Introduces 2-In-1 Seal & Lock Solution
Permatex Seal & Lock Thread Compound combines the sealing capabilities of a thread sealant with the holding power of a blue, medium-strength threadlocker Seal & Lock provides increased reliability and durability of repairs by ensuring sealed connections will not leak and locked fittings will not loosen. This specially formulated compound creates an air and watertight
MLS Gasket Update
The days of getting away with composition gaskets in extreme combustion situations were back when the deck surfaces on blocks and heads were thick and strong, and the heads were clamped with 5-6 head bolts per cylinder. However, all that changed when car makers became extremely weight conscious for MPG reasons and they started removing material out of blocks and heads.
Tech Tip: Fixing The Honda Accord, CR-V Rattle At Start Up
If a Honda, including the 2008-2012 Accord, 2012-2013 CR-V, and 2012-2013 Crosstour, has a pronounced rattling noise emanating from the engine during cold start-up, persisting for approximately two seconds, then this symptom is typically indicative of a defective Variable Valve Timing Control (VTC) actuator, as outlined in Technical Service Bulletin (TSB) 09-010. The corrective action
Permatex Partners With Polimotor To Help Build Engines Of The Future
The Polimotor team uses Permatex Sealants and Gasket Makers exclusively on the Polimotor 2, which is built without the use of any traditional preformed gaskets other than the head gasket.
Oxygen Sensor And Catalyst Efficiency
The catalyst efficiency monitor verifies the catalytic converter is operating at a high enough efficiency rating to keep exhaust emissions within the predetermined values. The PCM compares the signals from the upstream and downstream oxygen sensors to determine the state of the converter. These “tests” are called the readiness monitors.
Head Gasket FAQs
Replacing a head gasket is a significant investment for the customer. It also represents significant risk for a shop if the replacement gasket fails. To do the job right, you have to ask why the gasket failed in the first place and what it will take to prevent it from happening again.
Servicing TPMS Sensors
Most TPMS sensors are held in using just a screw or a nut, but if not assembled or torqued properly, the results can be catastrophic. Carelessness can result in a broken sensor or even a customer stranded with a flat tire.
Sealing Modern Water Pumps
Over the past 20 years, we have seen water pumps and cooling systems evolve to improve start-up emissions. We have also seen a revolution in the material used for engine blocks, cylinder heads and cooling system components. Today, coolant may flow through an iron block, aluminum cylinder head and plastic thermostat housing.
ASE A1 Task List: Gaskets
Passing the ASE A1 can be difficult. Do not go into this test with the notion that this is an exam for engine rebuilders. Many of the tasks in the A1 task list are required every day at general repair shops for top-end engine repairs.
Chicopee Launches High-Performance VeraClean Wiping Solutions
Engineered for the automotive industry, the wipes offer wet, dry and low lint options that allow professionals to start right, work less and produce more.
