10 Tips on Tightening
The installation of gaskets is one of the most important aspects of rebuilding an engine. Gaskets provide a seal between mating surfaces so oil, coolant, vacuum and pressure don’t leak. As long as all the gaskets are installed properly, everything should be fine, and the engine shouldn’t leak. But, as every rebuilder or technician knows,
Chrysler Neon 2.0L
When Chrysler introduced their new Neon models back in 1995 under the Dodge and Plymouth nameplates, they said they were launching a new generation of “fun-to-drive” entry-level cars that would appeal to a wide range of people. Everything was new about the Neon: a brand new body, a brand new chassis and two new engines,
OBD II Diagnostics:Tips And Tricks to Make the Process Easier
The Malfunction Indicator Lamp (MIL) can be a golden light of opportunity for your shop. If the light comes on, it means the Onboard Diagnostics II system (OBD II) has detected an emissions-related problem. OBD II is designed to turn on the MIL if a problem occurs that may cause emissions to exceed federal limits
Diagnosing and Fixing Compressor Failures
The compressor is the heart of the refrigeration circuit. It pumps and pressurizes the refrigerant to move it through the A/C system. Compressors work hard and run hot, up to several hundred degrees and several hundred pounds per square inch of internal pressure, yet they rely on only a few ounces of lubricant to keep
Mass Air Flow Operation Strategy
When diagnosing hot-wire air flow meters (A/F meters) on Subarus and similarly equipped Asian vehicles, technicians may find that, while the meter passes all recommended test procedures, the engine exhibits driveability conditions associated with lean air/fuel mixture ratios. In these cases, it’s best to form a diagnostic strategy based on the relatively simple operating principles
Muscling in on Restoration & Performance Work: Part 1
As automotive technology continues to become more complex with each new model year, you may be longing for the “good ol’ days” when engines had carburetors and distributors but no sensors, fuel injectors or computers. Most driveability problems were fairly simple to diagnose and only required a trained ear and a few basic tools. Alas,
Hot Heads for Cool Cars
The numbers are not huge yet, but there is a growing demand for high-performance cylinder head work and other engine modifications on a variety of sport compact cars. The most popular nameplates are imports such as Honda, Acura and Mitsubishi, but coming on fast are Nissan, Toyota, Mazda, Subaru and Volkswagen – plus domestic models
Oil Change Intervals
Contaminants Can Be Engine Killers Contaminants tend to accumulate in all engines as the miles add up. Short-trip, stop-and-go city driving, as well as excessive idling, accelerate the rate at which these contaminants form. Changing the oil and filter regularly and using gasoline that contains an adequate amount of detergent to keep the fuel system,
Transmissions & Clutches
The Ins and Outs of Manual Gear Box Repair
Understanding Today’s Multi-Coil Ignition Systems
Distributorless Ignition Systems (DIS) have been around for more than two decades, but in recent years the trend has been to multi-coil systems such as Coil On Plug (COP) or Coil Per Cylinder (CPC) ignition systems, and Coil Near Plug (CNP) ignition systems. COP systems have become the hot setup for a number of packaging,