VW DSG Transmission: Fluid Maintenance & Service

VW DSG Transmission: Fluid Maintenance & Service

Most of the drivers who will own a Volkswagen car or truck with a Direct Shift Gearbox (DSG) will not know they have a dual-clutch transmission connected to the engine. Most of them will think they have an automatic that gets excellent gas mileage. It is not until a transmission component fails or a service interval elapses that they learn about DSG.


Most of the drivers who will own a Volkswagen car or truck with a Direct Shift Gearbox (DSG) will not know they have a dual-clutch transmission connected to the engine. Most of them will think they have an automatic that gets excellent gas mileage. It is not until a transmission component fails or a service interval elapses that they learn about DSG.

WHY DSG
A DSG transmission is lighter than a comparable automatic with the same number of speeds. And, less weight equals better fuel efficiency.
Internally, the dual-clutch transmission is more efficient than an automatic because there are fewer moving parts. With an automatic transmission, the engine has to drive a pump and energy is lost in the torque converter and clutch packs.

LUBRICATING HYDRAULIC FLUID
Instead of a linkage connected to a shifter, the shift forks are actuated by hydraulic solenoids. The actual shifting is done by opening one clutch and closing the other, and maintaining the power flow. The shifting behavior can be fine-tuned by software that allows very different characteristics using the same DSG transmission.

Volkswagen uses a wet clutch setup. The transmission fluid lubricates and cools the clutches, and it contains friction modifiers that influence the friction level of the clutches. These additives can become depleted over time.

The same fluid that lubricates the clutches also lubricates the internal components of the transmission. Like with a manual transmission, the shock loads of the gears can degrade the fluid over time.

The fluid also acts as a hydraulic fluid. Hydraulic solenoids engage the DSG clutch and gears on the shafts. If the fluid is contaminated or oxidized, it can damage the solenoid’s seals causing internal leaks, or gum up the operation of the solenoid.

FLUID SERVICE
Fluid maintenance is key in keeping a VW DSG transmission operating as designed. Volkswagen recommends a 150,000 fluid service interval for most DSG transmissions, but recommends a more frequent service interval if the vehicle is used for severe-duty or towing applications. Check the service information for the correct interval.

Most DSG transmissions have a cartridge filter on top of the transmission. Unfortunately, it is under the battery and/or air filter housing. Replace the filter before you drain the transmission. The housing contains the most contaminated fluid. Draining the filter housing causes this fluid to go back into the case.

VW’s specification for most DSG transmissions is G 052 182 A2, G 052 182 A6 or TL 521 82. Make sure the replacement fluid meets or exceeds these specifications.

You May Also Like

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Millimeters Matter

When you set up a target or fixture for a camera or radar, the position and distance from the vehicle are critical to the performance and operation of the system. If the target or fixture is a few millimeters off when placed a few meters from the sensor, it can change the alignment of the sensor by meters when it is pointed down the road or the vehicle’s height is in the blind spot.

Differentials And Diagnostics

A differential allows the two connected wheels to spin at different rates.

Throttle-By-Wire Diagnostics

Throttle-by-wire systems proactively manage the air and fuel going into the combustion chamber.

Different Nameplates, Different Expectations

One thing Asian nameplates share is that the system voltage must stay in a specific range during the reflashing procedure.

Mode $06 Misfire Diagnosis

Understanding why ‘Mode $06’ was developed and how it works to identify misfires.

Other Posts

Hyundai & Kia Hybrid Drivetrain

The Hyundai hybrid system has a motor control unit (MCU) and hybrid control unit (HCU).

Auxiliary Cooling Pumps

An auxiliary cooling pumps primary function is to circulate warm coolant to the heater core.

Do You Know The Cause Of A No-Spark Condition?

A no-spark condition could be the result of communication errors or missing data from a dead module.

Diagnostic Procedures For Stop/Start Systems

Stop/start technology is more than just a switch wired to the brake pedal and starter.