Volkswagen Tech Tip: Humming Noise From Front of Vehicle During Cornering – UnderhoodService

Volkswagen Tech Tip: Humming Noise From Front of Vehicle During Cornering

A humming sound coming from the general area of the front end may be noticeable on 1998 Beetles during slow-speed turning with the steering wheel almost to the full turning position. The noise may be generated from the differential spider gear contacting the one-piece thrust washer under load. In addition, the noise goes away when the steering wheel is returned to the center position.

A humming sound coming from the general area of the front end may be noticeable on 1998 Beetles during slow-speed turning with the steering wheel almost to the full turning position.

The noise may be generated from the differential spider gear contacting the one-piece thrust washer under load. In addition, the noise goes away when the steering wheel is returned to the center position.

SERVICE PROCEDURE
If vehicle exhibits this condition:
1. Drain the transmission fluid.
2. Refill the transmission with oil p/n G 052 171 (see VESIS for fill quantities).
Caution: Part numbers are only for reference. Always check with your parts source for the latest parts information.
3. Road test vehicle to confirm that noise has been eliminated.

Technical service bulletin courtesy of ALLDATA.

You May Also Like

BMW Daytime Running Lights Are Dim

The issue is likely because the connection between the LED module & light tube inside the headlight is damaged.

Shop Boss Releases Shop Management User Interface

The upgraded interface focuses on multi-device capability with shops owners often operating “on the go.”

Replacement Alternator Pulley Problems

Replace the OAD and tensioner with the belt as part of a mileage-based service. Sponsored by Litens.

Litens Introduces “Reset to OE” Campaign

When replacing an OE alternator that came equipped with a OAD, it’s critical to replace with an OAD equipped alternator.

Sensata Introduces Bidirectional Contactors for EV Charging

The new contactors are for high-power applications like energy storage systems, DC fast charging and HD vehicles.

Other Posts

Inspection Tips For Chain-Driven Water Pumps

If one water pump fails sooner and is replaced without an investigation, the new pump is likely doomed.

Water pump feature
Throttle-By-Wire Diagnostics

Throttle-by-wire systems proactively manage the air and fuel going into the combustion chamber.

Hyundai & Kia Hybrid Drivetrain

The Hyundai hybrid system has a motor control unit (MCU) and hybrid control unit (HCU).

Flash, Qmerit Partner to Advance EV Charging in the U.S.

Qmerit’s maintenance network will provide Flash with a single source for maintenance across its charging locations.