Volkswagen Tech Tip: Humming Noise During Cornering – UnderhoodService

Volkswagen Tech Tip: Humming Noise During Cornering

A humming sound coming from the general area of the front end of an affected vehicle (see article for list) may be noticeable during slow speed turns with the steering wheel almost to full-turning position. The noise goes away when the steering wheel is returned to the center position.

A humming sound coming from the general area of the front end of an affected vehicle (see below) may be noticeable during slow speed turns with the steering wheel almost to full-turning position. The noise goes away when the steering wheel is returned to the center position.

Affected Models:
• 1998-on New Beetle w/02J transmission; and
• 1999-on New Golf, New Jetta w/02J transmission.

The noise may be generated from a differential spider gear contacting the one-piece thrust washer under load.

Service Procedure:
If a vehicle exhibits this condition, do the following:
1. Drain the transmission fluid.
2. Refill the transmission with oil P/N G 052 171 (see VESIS for fill quantities).
Note: Part numbers are for reference only. Always check for the latest parts information.
3. Road-test the vehicle to confirm that the noise has been eliminated.

Technical service bulletin courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Inspection Tips For Chain-Driven Water Pumps

If one water pump fails sooner and is replaced without an investigation, the new pump is likely doomed.

Water pump feature

Automakers are always trying to remove items from the accessory drive belt. This improves the efficiency of the engine and can extend the life of the belt. But where do you put the water pump? Some manufacturers like Ford and Mazda have driven the pumps with a pulley on the exhaust camshaft. Other manufacturers have decided that the chain on the front of the engine may be a better solution.

Throttle-By-Wire Diagnostics

Throttle-by-wire systems proactively manage the air and fuel going into the combustion chamber.

Hyundai & Kia Hybrid Drivetrain

The Hyundai hybrid system has a motor control unit (MCU) and hybrid control unit (HCU).

Flash, Qmerit Partner to Advance EV Charging in the U.S.

Qmerit’s maintenance network will provide Flash with a single source for maintenance across its charging locations.

Acura Turbo Engine Service

It is important to check the operation of the solenoids that control vacuum to the actuators.

Other Posts

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.

Subaru EJ25 Head Gasket Problems

Most of the EJ head gasket failures occur around the 100,000-mile mark and start as a slow oil or coolant leak.

Report: U.S. EV Investments Rapidly Increasing

Electric vehicle and battery manufacturing grew by a reported $92.3 billion over the past 12 months.

Different Nameplates, Different Expectations

One thing Asian nameplates share is that the system voltage must stay in a specific range during the reflashing procedure.