Tech Tips: Active Radius And Its Effect On Clutch Torque Capacity – UnderhoodService

Tech Tips: Active Radius And Its Effect On Clutch Torque Capacity

Many newer-design clutch friction discs are

active radius 4.704When automotive technicians order parts for a ­repair job they know they need the right part, and a quality part as well.

So it’s just a common procedure of any repair job that technicians will inspect the new part to make sure it is a correct part as well as a quality part, without any visual or functional flaws that would lead to a poor repair job and a customer comeback.

Many newer-design clutch friction discs are ­designed with a thinner band of friction material than the original disc that came in the vehicle.

The thinner band of material on the newer design may seem like a bad thing to some technicians as they compare the new and original parts that came out of the vehicle.

 Active radius 4.367

Conventional thinking would be that “more is better;” more friction material will mean a stronger clutch.

The active radius of a friction disc is defined as the distance from the center of the disc’s splined hub to the center of the friction material.

So, by using a thinner band of friction material on the disc, the active radius will be increased.

The active radius can be thought of as a lever. The longer the lever, the easier it is to move a given load.  

The above images illustrate how a thinner band of friction material will increase active radius and, therefore, the torque capacity of a clutch.

The disc on the top has a thinner band of friction material than the disc on the right.

This will increase the ­active ­radius and torque capacity of a clutch.

Courtesy of Schaeffler Automotive Aftermarket

You May Also Like

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

In the 1960s, coolant was changed twice a year. In the fall, antifreeze with ethylene glycol-based coolant was put into the engine to prevent the coolant from freezing and cracking the block when a cold front hit. Often, if the engine got hot, the antifreeze would boil off. In the spring, the engine would be drained and filled with water and maybe a small can of an anti-corrosion treatment.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.

Other Posts

Carbon Deposits and Direct Injection Engines

The primary cause of these problems is that fuel and added detergents are not hitting the back of the intake valves.

Acura Turbo Engine Service

It is important to check the operation of the solenoids that control vacuum to the actuators.

Subaru EJ25 Head Gasket Problems

Most of the EJ head gasket failures occur around the 100,000-mile mark and start as a slow oil or coolant leak.

New Oil Specifications

Many 0W16 oils have a new donut certification mark on the bottle called API SN-PLUS and SN-PLUS Resource Conserving.