Tech Tip: Whine, Growl or Vibration Type Noise from Buick Engine Compartment – UnderhoodService

Tech Tip: Whine, Growl or Vibration Type Noise from Buick Engine Compartment

There may be a whine and or growl noise from the engine compartment accompanied by a vibration during various driving conditions. This may include vehicle acceleration/deceleration, steering input and cornering left. It may be mistaken as a transmission noise or power steering pump concern.

Models:
2010 Buick Allure/LaCrosse

Condition/Concern:
There may be a whine and or growl noise from the engine compartment accompanied by a vibration during various driving conditions.

Figure 1This may include vehicle acceleration/deceleration, steering input and cornering left.

It may be mistaken as a transmission noise or power steering pump concern.

Recommendation/Instructions:
There are two identified areas that technicians should inspect the power steering lines for a ground out condition. The first area to inspect is the frame/bulkhead on the passenger side rear of engine compartment.

It’s easier to raise the vehicle and look from underneath. Also inspect the aluminum power steering lines, making sure you have 1” of clearance between the lines and right frame rail.

(See Figure 1.)

If the condition is present, the lines should be loosened (banjo bolt below rear cylinder head) and repositioned away from any body parts. This procedure normally requires you to lift the vehicle to gain access to the banjo bolt. If you move the lines to gain more clearance, make sure you don’t move them too far, as you will cause a ground out of the aluminum lines to the rubber power steering reservoir lines.

Important: You will need to replace the banjo bolt washers (P/N 13305013) anytime you loosen the banjo bolt, as they are a one-time compression washer.

Courtesy of Identifix.

You May Also Like

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

If only battery voltage is present at the battery on a running engine, does this mean the alternator is “bad?” No, it does not. It only means that the alternator is not charging, but does not reveal why. Therefore, it does not point to a faulty alternator. All too often, the alternator is condemned by technicians due to this test alone. The cause could instead be a module that distributes the power to the vehicle and regulates the alternator.

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Tools To Service Serpentine Belts

Servicing the serpentine belt on some vehicles is a tough task.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Other Posts

Hybrid Vehicle Fluid Maintenance

There are opportunities your shop can’t pass up just because the car or SUV has a hybrid badge on the back.

Using a Scope

Ignition coil and plug diagnostics.

Scope-diagnostics
Repairing Wiring Harnesses

A guide to probing and poking.

Diagnostic Procedures For Stop/Start Systems

Stop/start technology is more than just a switch wired to the brake pedal and starter.