Tech Tip: TPMS Relearn Procedures

Tech Tip: TPMS Relearn Procedures

Double-check as you go that the steps are done correctly. There are no shortcuts to the relearn process.

Relearns are a necessary step but can be complicated as every vehicle model has a unique set of actions. Each step must be performed in a specific sequence in order for it to work properly. All too often, it is the relearn procedure that causes delays in TPMS service. 

There are a few things you can do to ensure the relearning process is as efficient as possible and help avoid wasted time in the bay. First, it is important to understand the difference between relearning a vehicle and programming a sensor. 

If you use a programmable sensor, the sensor is completely blank and needs to be programmed to the specific MMY of the vehicle being serviced using a compatible and updated TPMS tool. Relearning a vehicle is the process of telling the vehicle which sensor is located in each tire. This ensures the vehicle is reading the correct pressure and displaying their proper locations. 

Steps To A More Efficient Relearn Process:

Make sure you follow the relearn entirely and in the proper sequence. Double-check as you go that the steps are done correctly. There are no shortcuts to the relearn process.

Call right away. Don’t waste time. If you try everything and still can’t turn off the TPMS light, don’t wait to give your sensor manufacturer’s tech line a call and let them walk you through it.

When you call, make sure you have the tenth character of the VIN number ready to share. It symbolizes the model year and will be needed by your service representative.

Have your Diagnostic Trouble Codes (DTCs) ready to share with the service representative at the time of the call.

Make sure you know which sensor was originally removed from the vehicle and have it ready.

Also, consider creating or using your sensor manufacturer’s best practice sheet each and every time a TPMS service is performed. Your sensor manufacturer plays an important role in your success with TPMS, so ensure you are getting the proper resources from them.

Courtesy of Tire Review Magazine

You May Also Like

Rough Running GM Vehicle

This condition may be caused by an internal circuit board fault within the throttle body.

Rough Running, Reduced Engine Power, Service Engine Soon (SES) Light On, P0123 AND P0222

2020-2021 Chevrolet Silverado 2500/3500 w/6.6L 

L8T engine

2020-2021 GMC Sierra 2500/3500 w/6.6L L8T engine

Using a Scope

Ignition coil and plug diagnostics.

Scope-diagnostics
Diagnostic Procedures For Stop/Start Systems

Stop/start technology is more than just a switch wired to the brake pedal and starter.

Auxiliary Cooling Pumps

An auxiliary cooling pump’s primary function is to circulate warm coolant to the heater core.

Battery Management Means Knowing How It Ages

The battery may be fully charged, but you also need to measure how low the voltages go while the engine is cranking.

Other Posts

GM SuperCruise Unavailable

The cause of the condition may be due to the map module not having the latest software available for the road expansion map to update.

Tesla Model 3 TPMS Service

Resetting and programming TPMS sensors for a Tesla is a lot like any other vehicle, and the challenge is still the same: keeping the light off.

The February Digital Edition Is Ready Today!

Each issue includes technical content from Underhood Service.

Detecting Misfire And Knock Conditions

Knock sensors are mounted on the block near the base of the cylinder head.