Tech Tip: Subaru A/T Temp Light Flashing, But No DTCs Stored, Erratic Shifting Complaint – UnderhoodService

Tech Tip: Subaru A/T Temp Light Flashing, But No DTCs Stored, Erratic Shifting Complaint

If you encounter a late-model D4AT-equipped vehicle with an erratic shifting complaint, and possible a DTC P0712 in memory, there may be a poor connection in the transmission wiring harness. There have been cases of open circuits or high resistance isolated to the white plastic pass-through section of the transmission harness or the harness itself. It's important to note that the P0712 may not be set when the condition occurs.

If you encounter a late-model D4AT-equipped vehicle with an erratic shifting complaint, and possible a DTC P0712 in memory, there may be a poor connection in the transmission wiring harness. There have been cases of open circuits or high resistance isolated to the white plastic pass-through section of the transmission harness or the harness itself. It’s important to note that the P0712 may not be set when the condition occurs.

One way to check for trouble in the transmission harness is to road-test the car with the SSMIII connected and data for the transmission fluid temperature (TFT) sensor selected. It’s best to check this after a cold start. Normally, the temperature should read at or close to the ambient temperature when the vehicle is started cold.

While road-testing, if you see the TFT readings are way out of line or fluctuating up and down as the ­vehicle comes up to temperature, it’s likely that the transmission harness would be a good place to start your troubleshooting.

Service Procedure:

1. Disconnect the transmission harness connector at the bulkhead connector. “Wiggle test” the harness and the harness pass-through while monitoring the resistance of the TFT circuit with a DVOM. Pin locations and connector numbers will be different, ­depending on the model. Always refer to the applicable Subaru service manual’s wiring diagram for circuit identification. If the resistance changes while wiggling the harness, further investigation of the ­circuit should be done.

2. SSMIII — You can also perform the wiggle test while monitoring the transmission fluid temperature with the SSMIII. Look for any fluctuations in the transmission fluid temp while wiggling the harness at the pass-through. In some cases, it may be necessary to remove the transmission pan and split-half each leg of the TFT sensor circuit individually. It should also be noted that depending on the condition of the circuit, a check engine light may or may not be triggered.

In another case, the customer stated, the “transmission has a harsh shift and is slipping.” In this ­instance, the excessive resistance in the transmission harness caused an incorrect TFT input to the TCU. This resulted in the TCU never “seeing” a fluid temperature above 68°, therefore, the operational characteristics were never adjusted accordingly once the fluid reached normal operating temperature.

This incorrect input resulted in the customer’s ­concern, but did not set a check engine light. By recording transmission data with the SSMIII while duplicating the concern, it was easy to identify a fault with the TFT circuit. Further investigation revealed the harness problem.

The above are not the only causes of DTC P0712. It’s ­important to use proper diagnostic methods to fully check the entire circuit from the TCU to the TFT ­sensor.

Courtesy of Mitchell 1.

You May Also Like

Why Do Timing Chains Stretch?

As the timing chain wears, it can change the timing of the camshaft and crankshaft.

Timing chain stretch is not the stretching of the timing chain’s links, it is an elongation of the timing chain caused by wear to the chain’s components. The most common cause of timing chain stretch is lack of regular oil changes.

Worn-out oil can no longer lubricate the chain and will cause the rollers and links to wear against each other. As the chain runs around the camshaft and crankshaft gears, the movement between the rollers and links causes wear and elongation.

Carbon Deposits and Direct Injection Engines

The primary cause of these problems is that fuel and added detergents are not hitting the back of the intake valves.

Acura Turbo Engine Service

It is important to check the operation of the solenoids that control vacuum to the actuators.

Subaru EJ25 Head Gasket Problems

Most of the EJ head gasket failures occur around the 100,000-mile mark and start as a slow oil or coolant leak.

Honda Electronic Throttle Body Service Tips

Using care and following OEM procedures will help you to avoid unnecessary parts replacement and comebacks.

Other Posts

New Oil Specifications

Many 0W16 oils have a new donut certification mark on the bottle called API SN-PLUS and SN-PLUS Resource Conserving.

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

Ignition Systems

The ignition coil is a very simple and robust circuit.

Diagnosing Crankshaft Position Sensors

Modern engines need to know the position of the crankshaft and camshafts.