Tech Tip: Properly Setting Tapered Bearings Critical to Preventing Damage – UnderhoodService
Connect with us
Close Sidebar Panel Open Sidebar Panel

Passenger Compartment

Tech Tip: Properly Setting Tapered Bearings Critical to Preventing Damage

The amount of end play, or preload, existing in a mounted pair of bearings is vital to a vehicle’s performance. Too tight or too loose of a preload can result in a damaged bearing or alignment problems. Seals, brake components and tire operation may also be affected, according to the experts at The Timken Company.

Advertisement

The amount of end play, or preload, existing in a mounted pair of bearings is vital to a vehicle’s performance. Too tight or too loose of a preload can result in a damaged bearing or alignment problems. Seals, brake components and tire operation may also be affected, according to the experts at The Timken Company. In addition, improper bearing setting can negatively impact factory settings of camber and toe. To help technicians safely maintain tapered, the company has developed the following guide for both passenger car non-driven wheels and independent suspension rear axles:

Click Here to Read More
Advertisement

Setting For Passenger Car Non-Driven Wheel
There are several mounting methods for tapered single roller bearings. Some are more common than others. One of the most popular methods is mounting and adjusting the bearing setting with a bottle cap stamping, hexagonal nut, cotter pin and threaded shaft. This approach is typically used on passenger car front wheels in combination with a hardened tongue washer between the outboard bearing’s inner ring and the adjusting nut.

To adjust the setting of this bearing:
• Tighten the nut while turning the hub. When there is a slight bind on the bearing, the parts are seated correctly.
• Back off the nut one-sixth to one-fourth of a turn, or sufficiently to allow .001" to .007" of end play. Failure to back off adjusting the nut could cause the bearing to run hot and become damaged. The wheel could also lock or separate.
• Place the bottle-cap-type stamping over the nut and insert the cotter pin to prevent the nut from backing off.

Advertisement

Setting For Independent Suspension Rear Axles
Hardened surface nuts, tongue washers and outer jam nuts or lock nuts are commonly used for wheels with full floating rear axles and some front-wheel applications. To adjust the setting of this bearing:
• Tighten the nut while turning the hub. When there is a slight bind on the bearing, the parts are seated correctly.
• Back off the nut one-sixth to one-fourth of a turn or sufficiently to allow .001" to .007" of end play. Failure to back off adjusting the nut could cause the bearing to run hot and become damaged. The wheel could also lock or separate.
• Tighten the jam nut to remove thread clearance and to prevent the nut from backing off.

Advertisement

About The Timken Company’s Automotive Aftermarket
Headquartered in the U.S. with manufacturing and research facilities across the country and around the globe, Timken is dedicated to providing the automotive and heavy-truck aftermarket with OE quality products. From bearings, hub assemblies and seals to grease, kits and components, Timken delivers the quality and technical know-how needed to make repairs right the first time. For more information on Timken’s automotive aftermarket products, log on to www.timken.com/aftermarket, email [email protected] or call (866) 984-6536.

Advertisement

Proper maintenance and handling procedures are critical. Always follow installation instructions and maintain proper lubrication. TechTips is not intended to substitute for the specific recommendations of equipment suppliers. Every reasonable effort has been made to ensure the accuracy of the information contained in this writing, but no liability is accepted for errors, omissions or for any other reason.

Advertisement
Click to comment
Connect
UnderhoodService