Tech Tip: Lexus Fifth Gear Shudder – UnderhoodService

Tech Tip: Lexus Fifth Gear Shudder

Models affected: 2004-’05 LX 470 ­vehicles produced before the Production Change Effective VIN: JTJHT00W#53553516

Some 2004 and 2005 model year LX 470 vehicles may exhibit a shudder (or vibration) sensation, usually accompanied by a cyclic droning noise, when lightly accelerating (less than 15% throttle) after the transmission shifts into 5th gear (usually between 35 and 45 mph). This condition may be caused by water entering the transmission breather, contaminating the transmission fluid. The transmission breather has been changed to prevent water intrusion.

Repair Procedure:

1. Remove the automatic transmission with torque converter.

a. Disconnect the breather tube and transfer rear case hose No. 1 from the transmission breather skirt (vent). See Fig. 1.

Fig. 1

b. Remove the transmission with torque converter.

Refer to the Technical Information System (TIS), 2004 or 2005 model year LX 470 Repair Manual; ­Automatic Transmission: Automatic Transmission Unit: Removal.

2. Replace the transmission breather skirt (vent), P/N 35123–60060.

– Remove the bolt and replace the transmission breather skirt (vent). See Fig. 2.

Torque: 12 Nm (122 kgf cm, 8.9 fts.-lbf)

Fig. 2

3. Install the new automatic transmission with the new torque converter, P/N 35010–60A00–84.

Refer to TIS, 2004 or 2005 model year LX 470 ­Repair Manual; Automatic Transmission: Automatic Transmission Unit: Removal.

a. Reconnect the breather tube and transfer rear case hose No. 1 to the transmission breather skirt (vent).

4. Adjust the fluid level in the transmission. Refer to TIS, 2004 or 2005 model year LX 470 Repair Manual; Diagnostics: Automatic Transmission: Pre-Check.

5. Road-test and confirm proper transmission ­operation.

Courtesy of Identifix, Inc.

You May Also Like

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

If a vehicle is overheating, the diagnostic process has become more complicated in modern cooling systems. Part of the reason is cooling systems have become more integrated with the engine management and emissions reduction systems. Old cooling systems reacted to heat generated by the engine. New systems anticipate and influence changes in coolant temperature. 

How (And Why!) To Clean An Engine

Beauty is more than skin deep. Here are 11 steps to help clean any car’s engine compartment.

Spark Plug Fouling

Understanding why spark plugs get dirty.

Aging Plastic Intake Components May Cause Leaks

BMW valve covers and intake manifolds made of plastic are susceptible to warpage and gasket failure.

Diagnosing Intercooler Boost Trouble Code P0299

The criteria for setting the code is very basic.

Other Posts

Understanding Coolants

All-season coolant used inorganic acid technology and worked great for almost 30 years.

Misfire Codes P0300, P0301-P0312 and P0313+P0314

The only way to clear the code is to use a crankshaft position relearn with a scan tool.

Belt-In-Oil Timing Systems

Oil contamination of the belt drive has been a death sentence, due to the rubber and fiber construction of the belt.

What Caused The Turbo To fail?

Up to 50% of turbocharger failures are due to oiling problems.