Tech Tip: Getting Your (Piston) Groove Back
The piston ring set and the piston must be engineered to complement each other from a standpoint of clearance between the back of the piston ring and the bottom of the piston groove. This clearance is referred to as back clearance. If the clearance is not sufficient, severe engine damage can result when the piston and rings are installed in the engine.
Tech Tip: Ford Camshaft Tick Noise
Some of the affected vehicles built Jan. 17, 2006 and later equipped with the 3.0L 4V Duratec engine with exhaust camshaft-driven water pumps may exhibit a ticking noise from the left bank cylinder head with the engine at normal operating temperature.
Compression Ring Seating: When is a Piston Ring Seated?
There has been some confusion concerning piston ring seating. Some ring sets have been returned to the manufacturer with the comment “the rings didn’t seat,” however, when the rings were examined they had 360 degree continuous contact on the O.D. face. This contact is indicative of total ring sealing.
Tech Feature: Straight Up Look at the Vortec 3500 Straight-Five Engine
The five-cylinder was seen as a way to achieve better fuel economy and performance than the six, but with more power and torque than the four.
Cylinder Head Sealing – Gasket Surface Machining Is The Most Critical Area of Cylinder Head Repair
Early this year, I had a chat with a technical representative for a major aftermarket gasket manufacturer who shed some light on some of the problems facing the cylinder head gasket market. According to this representative, the relatively short production life of modern engines also shortens the time that an aftermarket gasket company needs to
Tech Spec: Tackling Old Timers – Salvaging Pre-War Era Engines
It’s often surprising to some people that parts for these cars are still available. For other engine specialists, it’s sometimes more surprising when they aren’t.
Tech Tip: Gaskets from Different Eras Vary Quite a Bit from More Modern Vehicles
When selling engine gaskets, the modern parts professional is often faced with a dizzying array of gasket technologies. The difference in gasket technologies among a ’50s-model pickup truck, a ’60s-vintage, high-compression muscle car and a modern bi-metal or aluminum engine is often quite dramatic.
Tech Tip: How to Check Piston Ring Groove Back Clearance
It is extremely important to check rings for sufficient back clearance to verify correct ring set application for the engine. The piston ring set and the piston must be engineered to complement each other from a standpoint of clearance between the back of the piston ring and the bottom of the piston groove.
Tech Tip: Top 10 ‘DOs’ of Piston Ring Installation
Here are 10 brief pointers from Hastings Piston Rings on how to properly install piston rings and avoid a comeback.
Tech Tip: Destroking or Decompressing Pistons
A destroked piston is a piston that may have as much as .020″ or more removed from the top of the piston. This may be done by machining the top of the piston, or reducing the thickness of the head in the original casting.
Engines Sealed with Fel-Pro PermaTorque MLS Head Gaskets Dominate Top 10 in NASCAR 5-Hour Energy 500 at Pocono
Engines sealed with Federal-Mogul’s Fel-Pro PermaTorque MLS (multi-layer-steel) head gaskets swept the top seven and nine of the top 10 positions in Sunday’s NASCAR 5-Hour Energy 500 Sprint Cup race at Pocono Raceway.
Tech Tip: Toyota Matrix MIL ON/DTC’s P0011, P0012 or P0016 Set
Under certain conditions, customers may experience an MIL On condition with DTC P0011, P0012 or P0016 stored in the Engine Control Module/ECM.