Diagnostic Dilemmas: Battery-Related Driveability Issues

Diagnostic Dilemmas: Battery-Related Driveability Issues

Any experienced automotive trainer will tell you that the automotive starter battery is the foundation of a vehicle electronics system. Of course, most of us nod our heads in agreement and then proceed to diagnose a driveability problem without first testing the battery’s condition! Unfortunately, short-cut procedures don’t work on the really tough no-code engine driveability complaints. As we’ll discover in the following article, low cranking voltages can create no-code driveability issues that may disappear without a trace until the next cold-engine start-up.

Battery Voltage
Many technicians assume that because the engine seems to crank at a normal speed, the vehicle’s starter battery is in good condition. Of course, time and technology has changed the underpinnings of that assumption. Electronic fuel injection and the permanent magnet, reduction-gear starter, for example, has reduced cranking time and cranking amperage so much that bad batteries often go undetected far longer than they should.

The key diagnostic issue, of course, is the cranking voltage that the battery supplies to the vehicle’s electronic systems during cranking. Cranking voltage has become extremely important because at least 10 volts are required to power the PCM and activate systems like the primary ignition, fuel pump and fuel pump relay. When cranking voltages drop to nine cranking volts, it is my experience that engine fuel trim and transmission adaptives are affected to the point that the driver may complain of flooding or poor shift quality. Later in this story, we’ll look at some case studies that illustrate different starting and driveability complaints caused by low cranking voltage.

Battery Ratings
Modern automotive starter batteries are rated in cold-cranking amperes (CCA), cranking amperes and reserve capacity. CCA is the number of cranking amps that a battery can supply at 0

You May Also Like

Ford Adaptive Cruise Control Alignment Process

Follow these steps for proper horizontal alignment of the cruise control module radar sensor.

• 2010-2017 Taurus, Explorer, Edge, Flex, Fusion, MKS, MKX, MKT, MKZ

• 2015-2017 F150, Mustang, and MKC 

• 2017 Super Duty, Escape, and Continental

This is information on setting up and completion steps for proper horizontal alignment of the cruise control module (C-CM) radar sensor.

Chrysler’s Totally Integrated Power Module Simplifies Circuits

The symptoms of a failing TIPM can vary depending on the vehicle. Check out your options for this repair.

Trakmotive Tech Tip: Window Regulator Installation

Here are eight tips to make your next window regulator replacement easier.

Multi-Spark Ignition Systems

You may have seen the stories about plasma or laser ignition systems that promise to give new life to the internal combustion engine. But while these ignition systems have yet to make it to market the latest ignition innovation still uses a coil and spark plug.

VIDEO: How Modules Manage Alternator Power

Andrew Markel discusses power flow through the electrical system on a vehicle, and how the modules help provide the right amount of power to different components. Sponsored by Valeo.

Other Posts

Alternator Testing For No Charge Conditions

Many alternator problems turn out to be nothing more than a bad connection at the alternator or a bad wiring harness.

Battery Management Means Knowing How It Ages

The battery may be fully charged, but you also need to measure how low the voltages go while the engine is cranking.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Power Window Regulator and Motor Service

Power windows are great as long as they roll up and down when commanded to do so.