BMW Tech Tip: Ignition Lock Spins Freely – UnderhoodService

BMW Tech Tip: Ignition Lock Spins Freely

The ignition lock cylinder on E31, E36, E38 and E39 models built prior to January 1999 was designed with an actuating tab that breaks off if forcing of the lock is attempted with the wrong key, or with some form of tool as part of a vehicle theft effort.

The ignition lock cylinder on E31, E36, E38 and E39 models built prior to January 1999 was designed with an actuating tab that breaks off if forcing of the lock is attempted with the wrong key, or with some form of tool as part of a vehicle theft effort.

The purpose of the breakaway tab is to prevent the lock assembly from being forced to the point where the cylinder breaks out of the housing, allowing the steering lock to release and the ignition switch to be turned with a screwdriver. Since the cylinder will spin freely, the required force cannot be applied to the assembly.

It’s possible to break off the tab if enough force is applied to the proper key, and the key has not been inserted completely into the cylinder. Even if the tab has been broken off, the lock will still operate, as long as the correct key is completely inserted into the lock.

Service Procedure:
If the tab has been broken off, the lock cylinder can be replaced, following repair manual instructions, Section 32 32 050. When the cylinder is removed, carefully inspect the inside of the housing to locate the tab and remove all broken-off pieces. It’s normally not necessary to replace the housing unless damage to the inside of the housing is evident.

Courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Check The TSBs!

With the complexity of today’s modern vehicles, as technicians, we are going to have to stay on top of our game.

Over the last 28 years of being a technician, I have developed the habit of checking for and reading technical service bulletins at the forefront of the diagnostic process, especially when an unfamiliar vehicle exhibiting blatant or straightforward concerns comes into the shop. I have found many valuable nuggets of information while reading over these bulletins, from wiring concerns and connector issues, to transfer noises, water leaks, and engine and transmission performance concerns. The knowledge gained in reading through these bulletins has not only helped me with the vehicles I’m working on, but also increased my perspective and ability to connect the dots on other vehicles that don’t pertain to a current bulletin.

HVAC Heat Pumps

In theory, heat pumps can be three to four times more energy-efficient than conventional electric heaters.

AMN Drivetime: Cal Ganda’s Continental Journey

Ganda embodies servitude leadership, prioritizing team success and customer-centricity.

Auxiliary Water Pump Diagnostics

A car or truck comes into your shop with a complaint of poor heater performance- the issue may be the auxiliary water pump.

Misfire Codes P0300, P0301-P0312 and P0313+P0314

The only way to clear the code is to use a crankshaft position relearn with a scan tool.

Other Posts

Eaton to Supply ELocker Differential System to EV Manufacturer

The system leverages an electric motor to power the rear wheels and an electric motor or an optional ICE driving the front wheels.

Replacing Your Power Steering Reservoir

Discover why simply flushing out contaminants from power steering reservoirs may not be sufficient to prevent potential failures.

What Caused The Turbo To Fail?

Up to 50% of turbocharger failures are due to oiling problems.

Eli Opens Reservations for its Micro-EV in the US

The new Eli ZERO represents a new category of high-tech, efficient and sustainable micro-EVs, according to Eli Electric Vehicles.